Searching for an adhesive coating for floating floors or loose lay flooring? Selecting your adhesives for specific flooring installations shouldn’t be left to chance! Taylor Adhesives, available in Canada through Jona Panel Sales Inc., has technologically advanced, tries and tested flooring adhesives and coatings for all flooring types.
If you’re looking for an adhesive coating for floating floors and loose lay flooring your best bet is Gravity® by Taylor Adhesives™.
The Best Adhesive Coating for Loose Lay and Floating Floors
Taylor Gravity® is an anti-skid coating designed to be used with floating floors and loose lay flooring products. Gravity® can be applied to substrates such as concrete, chipcrete and plywood and can be utilized with LVT and LVP. Gravity® can also be used with products that are designed for free fit or loose lay carpet tiles as long as they are hardbacked and lay flat. Gravity can also work with SPC and WPC products.
Why use Gravity?
A big advantage with Gravity® is it’s not an adhesive but rather a nonskid coating, so what it does for you allows you to install your floor without permanently attaching it to the substrate so later on if you want to take up the floor and change the flooring tile, flooring OR if you wanted to take up the floor and change direction anything like that can be done very easily with Taylor’s Gravity®.
The flooring can be moved around very readily but once we put it on top of the gravity there’s no movement, however, you can take it right up no transfer no bond to the substrate. You can have the same result with an LVT product. It’s easy to move around but once it applied and placed there is no movement (see video).
Gravity® is very simple to apply. We apply it with a roller And this is going to just be a 38 inch roller with gravity. You can get moisture protection of the 85% relative humidity is a single coat 90% if it’s a two coat!
Gravity Fast Facts
- Approved substrates: concrete and radiant heated subfloors that do not exceed 85˚F (29.4˚C)
- Approved substrates where 2 coats are recommended: Gypsum, light weight concrete, APA underlayment grade plwyood and OSB
- One Coat: RH 85%, pH 5-12, MVER 5 lbs
- Two Coats: RH 90%, pH 5-12, MVER 10 lbs
- Cure time is approximately 2 hours per coat under acceptable humidity and temperature conditions
- Special tools: 3/8″ short nap paint roller
- Estimated coverage: 350 ft2/gal (1 coat) ~200 ft2/gal (2 coats)
Pin this for later
Get in touch to find Gravity at a distributor near you info@jonapanels.com